User manual

7 Change batteries of devices

The Basis Station will send you a Push message when the battery status of a device is low.

You will see a low battery status notification in the event list of your Smartphone. On the

main screen you will see a small battery sign next to the device.

For TX-85, TX-86 and TX-88 it is necessary to use CR123A 3V batteries. Open the device

with a flat cross-screwdriver and switch the old battery with the new one. Normally device

should reconnect automatically. If not activate the pairing mode of the Basis station and

then insert a new battery. If this does not work, the device has to be added again according

to chapter 5.1.2.

For TX-87 it is necessary to use CR2032 3V button cell battery. Change the battery by

using a screwdriver to remove the little screw on the back. Take a flat screwdriver carefully

into the gap of the housing to open it.

8 FAQ

Q: I cannot boot up intelligent alarm Basis Station? A: Please check device input power.

Q: After alarm is triggered, my mobile phone client did not receive push? A1: Please check

if network connection of Basis Station or router is normal. A2: Check to see whether the

Alarm Alert Manager is enabled in the APP “Subscribe Alert”.

Q: I failed to match accessory. A: The accessory may have the following problems: low

battery, other device has been connected, distance is too far (exceeding valid range).

Q: Accessory is triggered without any response. A: The accessory may have the following

problems: low battery, detector offline, exceed accessory detection range.

9 Technical Specification

9.1 WiFi Basis Station TX-91

Main process & OS Embedded Micro controller & Linux OS

Encryption basis station Sensor: 128bit-AES Encryption Algorithm

up to 32 detectors (868MHz)

Wireless connections

up to 6 remote controls

transmission distance ~10m (open areas)

Audio output Built-in loudspeaker (alarm tone only)

WiFi protocol IEEE802.11b/g/n, distance ~25m

Power supply (Micro USB) DC 5V/ 2A, max 10W

Working temperature –10°C up to +50°C

Installation Wall mounting, indoor only

Weight & Dimensions 96g / (L) 9.4x (W) 11.4 x (H) 1.8cm