User manual

23
Tip: When you want to refresh the detector list or the mode, just swipe to the bottom. The
following symbols can be shown in front of the device name:
the battery status of that device is low. Need to change the battery (CR123A 3V). If the
battery gets low you will receive a push notification.
the device is offline. Reasons can be that the distance between Basis Station and
detector/sensor is too big, there are interferences that interrupt the signal or battery is
empty. If the device is offline you will receive a push notification
6.1.4 Alarm Basis Station (Hub) Manager
By clicking on a connected device there are two options (see Figure 6-4).
Figure 6-4
Name: Set name of the device.
Username: Enter Username of device. Default is admin.
Password: Enter password of device. Default is admin.
Subscribe: Enable this option to get push notifications when alarm is
triggered.
Save: Press the disk on the top right corner.
Modify (pencil)
View Alarm Basis Station: Go to back to the device, with saving
settings.
Delete (trashcan) Delete the device from the APP. To reconnect see chapter 5.1.1
Connect Basis Station.