User manual

22
Name: Set name of the device.
Link Device: Select a device (camera or door phone). The live view of
the selected device will be shown when you open the push
notification.
Enable Siren: When the PIR Sensor is triggered the siren will be
activated. If you disable that function siren will not buzz or flash, when
the device is triggered.
Preview Link Device Video: Pressing this button shows you the live
view of the selected device that was chosen under “Link Device”.
Save: Press the disk on the top right corner on display.
PIR
Delete: The siren is disconnected from the Basis Station, until you
reconnect the device. See chapter 5.1.2 Add Detector & Siren.
Name: Set name of the device.
Link Device: Select a device (camera or door phone). The live view of
the selected device will be shown when you open the push
notification.
Enable Siren: When you press SOS button the siren will be activated.
If you disable that function siren will not buzz or flash, when the device
is triggered.
Preview Link Device Video: Pressing this button shows you the live
view of the selected device that was chosen under “Link Device”.
Save: Press the disk on the top right corner on display.
Remote
Delete: The siren is disconnected from the Basis Station, until you
reconnect the device. See chapter 5.1.2 Add Detector & Siren.
6.1.3 Change view of detector & siren list
By swiping down at the alarm Basis Station interface beneath the selected mode (Stay,
Away, Custom or Disarm) you can choose between two modes. 1. option is to display the
detector with their symbols. 2. option is to display the detector in a list (Figure 6-3 below)