User manual

21
Setting
(Gear)
Select for the different mode (Stay, Away, Custom and Disarm) which
detector should be activated.
Audio Setting
(loudspeaker)
Set the volume of the base station’s alarm tone. Set the volume of the
base station beteween mute, silent or loud. Note: this setting does not
affect the volume of the siren.
Tip: The alarm tone (buzzer) of Basis Station and siren can temporarily deactivated by
pressing on the function key of the Basis Station. Attention: After pressing the function key
is flashing blue. While the functions key is flashing blue no detector trigger is recognized.
Press functions key again to stop function key flashing blue. The function key must remain
permanently blue to ensure the detection of the detectors.
6.1.2 Setting of Detector & Siren
Press on the symbol of detector or siren you want to set. See Figure 6-2. below
Name: Set name of the device.
Save: Press the disk on the top right corner on display.
Siren
Delete: The siren is disconnected from the Basis Station, until you
reconnect the device. See chapter 5.1.2 Add Detector & Siren.
Name: Set name of the device.
Link Device: Select a device (camera or door phone). The live view of
the selected device will be shown when you open the push
notification.
Enable Siren: When the door contact is triggered the siren will be
activated. If you disable that function siren will not buzz or flash, when
the device is triggered.
Preview Link Device Video: Pressing this button shows you the live
view of the selected device that was chosen under “Link Device”.
Save: Press the disk on the top right corner on display.
Door
contact
Delete: The siren is disconnected from the Basis Station, until you
reconnect the device. See chapter 5.1.2 Add Detector & Siren.