User manual

5.3 TX-86 Door and Window Contact

Before you can normally use Door/Window Contact you must match device with Basis

Station.

Connection with Basis Station: Activate the paring mode at the Basis Station with the

function key and power on the detector. When red LED is blinking, dial vandal-proof switch

and indicator is flashing. Wait about 10 seconds. If the red LED is OFF, the matching is

successful. If the indicator flashes for three times, the matching is failed. You shall follow

these steps and try again.

Note: If the detector has been matched to other alarm host, you cancel previous matching

by quickly dialing vandal-proof switch. (5 times within 1 second)

5.4 Remote Control SOS Button TX-87

For adding the remote and button configuration see chapter 5.1.4 Add Remote Control

TX-87.

5.5 Alarm Siren TX-88

Before you can normally use Siren, you must match device with Basis Station.

Connection with Basis Station:

Activate the paring mode at the Basis Station with the function key and power on the

detector.

When red LED is blinking, dial vandal-proof switch and indicator is flashing. Wait about 10

seconds. If the red LED is OFF, the matching is successful. If the indicator flashes for three

times, the matching is failed. You shall follow these steps and try again.

Note: If the detector has been matched to other alarm host, you cancel previous matching

by quickly dialing vandal-proof switch. (5 times within 1 second).