User manual

5.1.3 Clear Detector / Siren Matching Info

If the detector needs to be used with new Basis Station or restored factory default, you can

operate according to the following steps. Quickly press the tamperproof switch of the case

for 5 times, clear the config info of the detector/siren, restore to the initial status. The

indicator light will be normally on for 6s and then flash if it clears successfully.

Tip: The operation above can be used to fix malfunctions.

5.1.4 Add Remote Control TX-87

It is to arm/disarm and enable emergency alarm after binding remote controller and Basis

Station via matching mode.

Step 1. Short press the function key of Basis Station to enter matching mode, and then the

blue LED light flashes quickly.

Step 2. Long press any key of the wireless remote control for 2s, and then the Basis Station

gives off the prompt tone of “beep”, which means it is successfully matched, otherwise,

matching failed, please match again. See Figure 5-6 below.

1 = Activate the alarm system (on the road)

2 = Home Mode (if you are at home)

3 = Deaktivate the alarm system

4 = Manuel Alarm (Emergency alarm)

Tip: Enter match mode, you can add several wireless remote controllers. This process will

take 120 seconds, and then auto exit matching mode, the blue LED light is normally on.

During the matching process, press function key on the Basis Station to manually end

matching. Emergency Alarm is a manual alarm that activates the Basis Station and siren

alarm only.

5.1.5 Delete Detector, Siren or Remote Control

Method 1 (delete individually): In APP check accessory

details and press on delete disconnect the connection to the

Basis Station.

Method 2 (delete all in one): Press the RESET button of the

Basis Station for 6 seconds, when the device is powered on.

The Basis Station restarts and is restored to factory default

settings (see Figure 5-7 right hand side) 3 = RESET