User manual

16
Step 6. To connect Detector & Siren with the Basis Station press function key of Basis
Station to enter the matching mode. Blue LED starts flashing. Now insert the battery into the
detector/siren you want to add. The Basis Station informs you with a beep that the
detector/siren is connected with the Basis Station. Same way for other detectors and sirens.
Matching mode will last for max. 120s or you turn it off by pressing function key of the Basis
Station again. To add. For adding remote control, see chapter 5.4. If you have any issues
follow the chapters below. Tip: For the first configuration of the Basis Station you use WiFi
configuration. After that you can use P2P connection and QR-code to add the Basis Station
of alarm system to other Smartphones.
5.1.2 Add Detector & Siren (TX-85, 86, 88)
In matching mode, it can add several detector and sirens in sequence. It is to realize
monitoring alarm when it is binded with Basis Station.
Step 1. Short press the function key of Basis Station to enter matching mode, then the blue
LED flashes quickly.
Step 2. Power on the detector/siren (by inserting battery or power input), auto enter
matching mode, it means it is successfully matched when the Basis Station gives off the
prompt tone of “beep”; otherwise the matching fails.
If matching fails, you can repeat the second step until it successfully matches, or you can
press the tamperproof switch by taking of the detector case and match manually.
Take wireless passive IR intrusion detector as an example, the location of tamperproof
switch is shown as follows: 1 = Case tamper proof switch
Figure 5-5
Tip: The matching process will last 120 seconds, after that it will auto exit matching mode,
the indicator light of the Basis Station becomes normally blue. You can press the function
key of the Basis Station to manually stop matching during the process.