User manual
6
4. Basics, Installation and Debug
4.1 Basic Function Introduction
TX-82 supports unlock by card and video talk with My Secure Pro App (or MGT center and
ISM). In order to take full advantage of the functions of the device, you need the additional
available TX-89 WiFi 7” Monitor (ISM).
4.1.1 Monitor
Download mobile phone App (My Secure Pro) and view video of TX-82 remotely. Refer to
chapter 6.4.3 P2P. (You can also watch live view local via ISM or MGT center.)
4.1.2 Call Function
Press call button on device, to call My Secure Pro App (or MGT center or ISM).
On ISM, press Unlock button to unlock door. When ISM picks up, you can start talk with
the ISM. If no one answers the call, then the call will end automatically and device returns
to Standby status (with connected ISM it is possible to leave a message on the MicroSD
card of the ISM). Refer to chapter 6.2 LAN Config
4.1.3 Unlock
Unlock by Card
At card swiping area on TX-82, swipe authorized RFID (NFC) chip, then you can unlock
door after passing verification. Refer to chapter 6.1.2 A&C Manager Issue Card
Unlock via WEB Interface
When you are in the WEB Interface System Config Video Set Video setup under the
live view is a button Open Door. By pressing this button you can also open the door. Over
WEB interface there will be no notification. Refer to chapter 5. WEB Interface.
Unlock by My Secure Pro App
When My Secure Pro is called, calling or monitoring, you can remotely unlock the door via
your Smartphone from home or from afar. TX-82 will return to standby mode after call ends
or countdown stops. Refer to chapter 9. Use of My Secure Pro.
Unlock by MGT Center
When center is called, calling or monitoring, center can remotely unlock the door. TX-82 will
return to standby mode after call ends or countdown stops. Refer to chapter 10. PC
Software (MGT Center).
Unlock by ISM (Only usable with additional ISM)
When ISM is called, calling or monitoring, ISM can remotely unlock door. TX-82 will return
to standby interface after call ends or countdown stops.