User manual

23
Step 2. Configure parameters, see Chart 6-10.
Parameter Note
IP Address
IP address of host where FTP server is installed. (Only IP address,
without ftp://)
Port No. Default is 21.
Username
Password
Access FTP server username and password.
Chart 6-10
Step 3. Click OK.
6.4.3 P2P
The P2P connection simplifies the access to the TX-82 from home and everywhere in the
world via your Smartphone. The Smartphone needs a stable Internet connection.
Step 1. Go to System Config  Network  P2P interface. See figure 6-11.
Figure 6-11
Step 2. Select to enable P2P server.
Step 3. Click OK, to save settings.
After setup is complete, “status” becomes “online” which means P2P registration is
successful. Scan QR code below to add device on mobile phone client if it has already
configurated via LAN or WiFi. (See chapter 9.1.1 WiFi configuration).