User manual

22
Parameter Note
Connection
LAN (Eth0): Connection via LAN (Ethernet) cable with router (wired).
WiFi (Eth2): Connection via WiFi with router (wireless).
IP Address Enter corresponding number to change IP address.
Subnet Mask
According to actual condition, set subnet mask which prefix is
number, enter 1～255，subnet mask prefix has a specific network
link, which includes one layer structure in general. (In your network
mostly the subnet mask is 255.255.255.0 addicted to router settings)
Default Gateway According to actual condition, it must be in the same IP segment.
MAC Address Display device MAC address..
DNS Address Enter the IP address of the DNS server (Router).
DHCP Enable, auto get IP function.
Default Interface
LAN (Eth0): Wired, by default select Ethernet card 1.
WiFi (Eth2): Wireless, by default select Ethernet card 2.
Default Click “Default”, restore all parameters in the page to default.
Refresh Click “Refresh”, refresh current page.
OK Click “OK” to save settings.
Chart 6-9
Tip: By the default activated DHCP protocol, the above mentioned settings are activated
automatically.
6.4.2 FTP
FTP server is used to store snapshot pictures. User can set their FTP server to snapshots
on it. Attention: You have to set up FTP server (please use third party to find out how to do),
after that you can use it to store (record) or/and snapshots on it.
Step 1. You can go to System Config  Network  FTP, to set local FTP network
parameter. See figure 6-10.
Figure 6-10