User manual

16
6.1.4 System Time
Go to System Config  Local Config  System Time (6-4). Here you can set date format,
time format (24-hour and 12-hour), and input system date and time. You can also click on
Sync PC to synchronize system time with PC time. You also can set DST (summertime)
start and end time.
Figure 6-4
Parameter Note
Date Format Set system date fomat.
Time Format Set system time format, there are 12-hour and 24-hour modes.
System Time Set system display time.
Sync PC Click “Sync PC”, to sync system time with local PC.
DST Enable
DST Type
Start Time
End Time
Check “DST Enable” box, to enable DST (summertime).
If you locate in place using DST, you can set DST accordingly. You
can select week mode or date mode to start and end DST.
NTP Enable
NTP Server
Zone
Port No.
NTP Update Period
Check “NTP Enable” box, to enable NTP server time sync
function.
You can set IP of NTP server, zone, port no. of NTP server and
update interval of NTP server .
Default Click “Default”, to restore default settings in this tab.
Refresh Click “Refresh” to refresh this page.
OK Click “OK” to save settings.
Chart 6-4