User manual

10
Step 1. According to position of bracket, drill hole on installation surface (such as wall).
Behind the device should be an installation box with the required connections DC
voltage 12V/1A and LAN cable (RJ-45).
Step 2. Insert expansion bolt in hole you just have drilled.
Step 3. Fix bracket on designated position with screw.
Step 4. Connect all necessary cables (power supply, door opener, LAN, etc.).
Step 5. Fix TX-82 with a screw to the bracket.
Step 6. Mount sealing element at rear of device.
Important:
 Make sure that you have enough space for the cable connection behind device.
 Make sure that the TX-82 and the door opener are provided with a separate power supply,
or that there is sufficient amperage from the bell transformer for the simulaneous operation
of both units.
Note: The recommended distance from device center to ground is 1.4m~1.6m.
4.5 Installation of TX-82
4.5.1 Installation via Ethernet cable
Warnings:
Debugging personnel shall be familiar with related materials, know device
installation, wiring and usage. Debugging personnel check whether circuit has short
circuit or open circuit or not. Make sure circuit is normal, plug device to power. After
debugging end, clear up site (handle plugs, fix device and etc.)
Default is DHCP, TX-82 will get IP automatically. (To find out IP address use Configtool to
search for, see chapter 10 Configtool.)
Steps to debug:
Step 1. Connect device to power, and power up. About 60s after plugging to power, it auto
boots up and enters working status. Indicator turns blue.
Step 2. Connect the TX-82 to the router via an Ethernet cable. In PC browser, enter device
default IP address 192.168.1.110 or use Config Tool to search for IP address in your
network. See figure 4-4.