User manual

Key (K1) functions and indicator LEDs description

Video recording: Long press K1 button, BLUE LED L1&L2 blink 3 times and turn off, it
starts recording videos.

Save videos: Short press K1, BLUE LED L1&L2 steady on. After 1 minute without any
operation the Power Bank will automatically shutdown.
Note: Maximum file length of video recording is 3 minutes, after that a new file is created.
Supports loop recording, when the memory card is full, it will remove an old file and add a
new file.

Infra-Red Mode: Under video recording mode, short press 2x K1 button, BLUE L3
flashes 3x; the infrared mode is activated. Short press the K1 button 2 times, BLUE L4
flashes 3x; the infrared mode is deactivated.

Recording while charging other devices (e.g. Smartphone): Press short K1 while
the other device (e.g. Smartphone) is connected to the USB port, BLUE LED L1&L2 are
steady on. Press short K1 to start a video recording. It is also possible to enable/disable
the IR-LED. Under video recording mode, short press K1 button 2 times, BLUE LED L3
flashes 3x; the infrared mode is activated. Short press the K1 2 times, BLUE LED L4
flashes 3x; the infrared mode is deactivated.

PC camera: Connect the Power Bank to a computer, when it shows a removable disk,
short press K1. Without MicroSD Card, the Power Bank will automatically go into PC
camera mode (WEB cam mode).

Set Date and Time stamp
The date and time will be revised for video in next recording. Plug in the Micro USB cable
to the camera and to the computer.
 Go on your PC to Explorer. The recordings of the camera will be recognized as
removable Disk Drive. In the folder “Video” you can see the recorded videos in .avi format.
 Open the <timerset.txt> file on the MicroSD card (double click with right mouse
button).
 Fill in the current Year.Month.Day. hour:minute:seconds [eg: 2017.04.20 23:59:59
StampMode:Y]. (Change”Y” to “N”, the time stamp will not show up).
 Save the changed file in the menu <Save File>. Then finish the Day/Time
formatting by <File/Close>.
 Power off the Power Bank and restart it. The Power Bank now has the current
date and the current time.

Reset: Press K2 button if the camera of the Power Bank does not operate properly.
How to use your Power Bank
 Connect the USB charging cable* (*not
included) of your device (which should be
charged) to the output port (USB) of the Power
Bank (see right picture).