User manual

 Replace the reversing lamp bulb and reinstall the lamp seat.
 Use the cable ties or insulation adhesive to fix all wires.
 After finishing the wiring, don’t forget to reattach the negative ground contact
to the battery.
Additional: If you use a wired monitor it will be necessary to connect the power/signal
output port of the camera to the power port of monitor. When you use a wired monitor,
please connect the video input port of the monitor to the video output port of the camera.
The camera will automatically export signal to the monitor.
Note: The camera is compatible with both wired mode and wireless mode.
Installation of the monitor
There are 2 ways of installing the monitor in
the car.
Use the suction holder to install the monitor.
The suction holder is stamped on the front window
glass.
Use the air holder to install the monitor. Special
holder is plugged into the ventilation slot of car air
conditioner.
Put the monitor at the correct side which is most
convenient for you and the power supply is long
enough for.
1RED
2BLACK
3 Ground
4 Reverse light / bulb
5 DC 12/24V of reverse
light / bulb