User manual

 Turn the ignition key to the “ON” position, but don’t start up the car. Put the gear shift in
the reverse position.
 Take a measuring device for DC 12/24V to locate the positive and negative pole of the
reversing bulb seat. Warning: Be careful and don’t short circuit the positive and negative
pole!
 Once you have confirmed the specific position of the reversing lamp circuitry, turn of the
ignition key.
 Remove the negative ground contact of the battery. Note: Please tighten the power
cable to avoid tangling of the power cable onto any car part.
 Reversing bulb seat on most cars have two wires. Normally, the black one is the
negative wire, while the colored one is the positive wire.
 After confirming which is the positive wire and which is the negative wire, distribute the
power cable of the camera to the right position.
1 Connection of the monitor 4 Reverse light (DC12/24V)
2 RED 5 Bulb of reverse light
3 BLACK 6 Ground
 Use the in-line wire connector, splice the red wire onto the (+) wire of the reversing
lamp by use of the red connector* (*included).
 Then splice the black wire of the cable of the camera on to the negative (-) wire or
grounding point of the reversing lamp.
 Use of the cable clamps (DO NOT attempt this if you are not knowledgeable with
electrical installation practices.)
The camera can be wired directly to the reverse light circuit
by stripping the reverse light wires.
Insert the existing wire to be tapped.
Then twisting the camera wires to the exposed reverse light
wires. Insert the wire to be attached.
Crimp tap and then close lock.
Once they are connected, wrap them with electrical tape.