User manual

When done all the above mentioned steps, you have to proceed step by step with
the following instructions:
 Engage the parking brake.
 Locate the reversing lamp of your car.
 Open the luggage compartment of your vehicle and remove the coverage of the
reversing lamp (like you want to change a bulb, maybe a special tool is needed).
 Remove the reversing bulb, to prevent damaging the bulb.
Forth step: Loosen the license plate again without
loosen the rearview camera. Drill one hole for the
power cable nearby the camera and behind the
incense plate location. If your car has an existing
hole, you can skip this step.
Attention: To not damage internal cable. The hole
for the power cable should be about 11-12mm.
Now it is possible to drill to more holes to secure the
rearview camera with screws. The drilled holes
should be a little bit smaller than the screws.
Depending on the thickness of the material use the
corresponding screws.
Fifth step: Put the power wire through the drilled
hole in to the car through the interstices of the car.
Reattach the license plate.
Note: In the wired mode, the user also needs to put
the connect cable through the car body to the wired
monitor.
Adjust the camera. You maybe have to adjust again
after you have powered the system.
Sixth step: You got the power supply
cable of the rearview camera to the rear
spotlight.
Use a voltage detector to find the power
supply of the rear spotlight for the reverse
gear. Follow the steps below: