User manual

Camera installation  Before starting with mounting and removing cover
off your car, adjust the system to your car and try it out!
READ THE INSTRUCTION FIRST, BEFORE INSTALLING THE REARVIEW CAMERA!
Note: You may have to disable the rear bumper bar, the rear spotlight and/or the luggage
compartment cover of your car. Check this possibility before mounting the rearview
camera. Reason is to get the power supply of the rearview camera from the reverse light
(when you put in the reverse gear of your car). Then remove all necessary cover to get the
power supply of the rearview camera to the reverse light. If this is not possible for you,
than you have to hire professional staff for installing the camera.
You have to notice that cars are different and therefore the installation has to be
individually. This manual will give two examples how to position the camera
depending on the positioning of your license plate. You have to distinguish between
license plate fixed to your luggage compartment or your rear bumper bar. The best
position for installing the rearview camera will be the bracket of rearview camera behind
the license plate.
First step: Loosen the license plate bolt or screw
and then remove the license plate on the rear of your
car. Temporary mount the rearview camera on top of
the license plate.
Luggage compartment: Hold the license plate to the
position it will be mounted and check if the handle of
the luggage compartment will be still reachable. If
not, you have to mount the camera on the bottom of
the license plate.
Rear bumper bar: Hold the license plate to the
position it will be mounted and check if the license
plate would fit with the camera on it. If not, you have
to mount the camera on the bottom of the license
plate.
Note: It does not matter if the camera is installed on
the top or the bottom of the license plate. The video
can be flipped on the monitor.
Second step: When you have found the right position to mount the camera and
everything will be reachable like the handle than clean the space behind the license
plate with fat solvent. A clean surface is better for mounting the adhesive from the
bracket of the rearview camera.
Third step: The rearview camera is still temporary
mounted on the license plate. Peel of the backing
paper of the bracket. Reinstall the license plate to the
car. Now press the license plate on the edge where
the rearview camera is placed firm against the car.
The adhesive has to touch the car over the whole
length.