User manual

4.1 How to install TX-29 & TX-30

See figure 4-1 above and follow the steps below.

① Plug in the included USB mouse to one of the USB connector.

② Connect the output of the supplied 12V power adapter into the power socket on the

NVR.

③ Plug the power adapter into the wall socket.

④ Connect the output of the supplied 12V power adapter into the power socket on the

Camera.

⑤ Plug the power adapter into the wall socket.

Wait for a few minutes till the TX-29/TX-30 and the IP camera finished startup. So far, the

local surveillance system was done.

⑥ If you want to remote access this system with a Smartphone or computer, you should

connect the TX-29/TX-30 to your home wireless router with a RJ45 network cable and

make sure the router has been linked to internet. For Smartphone installation see chapter

6.3 Mobile application (Security Premium).

4.2 Antenna installation

Use a clockwise motion to connect the antenna. Make sure the antenna is connected firmly

but not excessively. You can adjust antenna horizontal or vertical direction to get best

reception.

Monitor

Camera