User manual

Advanced

Multiply Network Segment

(not supported)

Multiply Network Segment means that

access a segment to add the device.

Allow Repeated Add

When enabled you can add the same

camera more than one time

Intelligent Add

Intelligent add is smart add

functionality. It is mainly used for the

wired camera. You can ignore it. The

intelligent add will check if the IP

camera and the NVR segment are the

same. If not, the NVR will change the

IP camera segment to be the same as

the NVR automatically.

Added devices:

Delete

Select a camera from the added device list and delete it!

Delete All

Delete all cameras in the added device list!

Manual Edit

Edit channel connection parameters. You can flip the image 180° with

Image Rollover.

Channel Setup

Press the button, then you get to main Channel Setup page. Here you

can change the Channel & Encode mode.

WiFi Setup

Press the button, then you get to main WiFi Setup page. Here you can

change or edit the SSID for better WiFi connection. Attention: If you

change SSID or Password you have to reconnect the cameras. See

chapter 4.4.

Repeater: Repeater function is for extending the range of the WiFi signal of the NVR. The

camera that is set as repeater has to be in the range of the NVR (open field 40m). The

camera that you will connect to the repeater camera should be in the range of 30m (open

field) to the repeater camera. Follow the steps below to install. Attention!: Don’t forget,

cameras that are connected by repeater function get all turned off when the first repeater is

disconnected from the power supply.