User manual

Refer to the following sheet for log parameter information.

Parameter

Function

Device

Click Device search button, you can view the searched device

information on the list. It includes device IP address, port, device

name, manufacturer and type.

Add

Select a device in the list and then click Add button, system can

connect the device automatically and add it to the Added device

list. Or you can double click one item in the list to add a device.

Modify

Click or any device in the Added device list, you can

change the corresponding channel setup.

Delete

Click , you can delete the remote connection of the

corresponding channel.

Connection

status

: Connection succeeded.

: Connection failed.

Delete

Select a device in the Added device list and then click Delete

button, system can disconnect the device and remove it from

the Added device list.

Manual Add

Click it, the interface is shown as in Figure 5-14. Here you can

add network camera manually.

You can select a channel from the dropdown list (Here only

shows disconnection channel.)

Note:

 System supports manufactures such as Panasonic, Sony,

Dynacolor, Samsung, AXIS, Arecont, Dahua and Onvif

standard protocol.

 If you do not input IP address here. System uses default IP

192.168.0.0 and system does not connect to this IP.

 Can not add two devices at the same time. Click OK button

here, system only connect to the corresponding device of

current channel.

5.8.1.2 Image

Note:

Slight difference may be found since the connected network camera may not be same

model.

Here you can view device property information. The setups become valid immediately after

you set. See Figure 5-15.