User manual

78
options: stop recording or rewrite. If current working HDD is overwritten or the current
HDD is full while the next HDD is no empty, then system stops recording, If the current
HDD is full and then next HDD is not empty, then system overwrites the previous files.
 Pack duration: Here is for you to specify record duration. The value ranges from 1 to 120
minutes. Default value is 60 minutes.
 Realtime play: It is to set playback time you can view in the preview interface. The value
ranges from 5 to 60 minutes.
 Auto logout: Here is for you to set auto logout interval once login user remains inactive for
a specified time. Value ranges from 0 to 60 minutes.
 Navigation bar: Check the box here, system displays the navigation bar on the interface.
 IP-CAM Time Sync: You can input an interval here to synchronize the TX-64 time and
IP-CAM time.
 Startup wizard: Once you check the box here, system will go to the startup wizard directly
when the system restarts the next time. Otherwise, it will go to the login interface.
 Mouse property: You can set double click speed via dragging the slide bard. You can
Click Default button to restore default setup.
Figure 4-110
4.13.2 Data and Time
From Main menu->Setting->System->General, you can go to the general interface. See
Figure 4-111.
 System time: Here is for you to set system time
 Date format: There are three types: YYYYY-MM-DD: MM-DD-YYYYY or DD-MM-YYYY
(default).
 Date separator: There are three denotations to separate date: dot, beeline and solidus.
 DST: Here you can set DST time (Day Light Saving Time) and date by week or by date.
Enable DST function and then select setup mode. Input start time and end time and click
―Save― button.
 Time format: There are two types: 24-hour mode (default) or 12-hour mode.
 NTP: It is to set NTP server, port and interval.
Note:
Since system time is very important, do not modify time casually unless there is a must!