User manual

73
4.11.1.9 P2P (EASY4IP)
The EASY4IP interface is shown as in Figure 4-101. You can scan the QR code to connect
the device over the My Secure Pro App.
Figure 4-101
4.11.2 Network Test
In this interface, you can see network test and network load information.
4.11.2.1 Network Test
From main menu->Info-Network->Test, the network test interface is shown as in Figure
4-102.
 Destination IP: Input valid IPV4 address.
 Test: Click it to test the connection with the destination IP address. The test results can
display average delay and packet loss rate and you can also view the network status as
OK, bad, no connection and etc.
4.11.2.2 Network Load
From main menu->Info-Network->Load, network load is shown as in Figure 4-102. Here you
can view the follow statistics of the device network adapter. Here you can view information of
all connected network adapters. The connection status is shown as offline if connection is
disconnected. Click one network adapter, you can view the flow statistics such as send rate
and receive rate at the top panel
Figure 4-102