User manual

70
Figure 4-95
Figure 4-96
4.11.1.6 IP Filter
IP filter interface is shown as in Figure 4-97. You can add IP in the following list. The list
supports max 64 IP addresses. System supports valid address of IPv4 and IPv6. Note
system needs to check the validity of all IPv6 addresses and implement optimization.
After you enabled trusted sites function, only the IP listed below can access current TX-64.
If you enable blocked sites function, the following listed IP addresses can not access current
TX-64.
 Enable: Highlight the box here, you can check the trusted site function and blocked sites
function. You can not see these two modes if the Enable button is grey.
 Type: You can select trusted site and blacklist from the dropdown list. You can view the IP
address on the following column.
 Start address/end address: Select one type from the dropdown list, you can input IP
address in the start address and end address. Now you can click Add IP address or Add
IP section to add.
a) For the newly added IP address, it is in enable status by default. Remove the √
before the item, and then current item is not in the list.
b) System max supports 64 items.
c) Address column supports IPv4 or IPv6 format. If it is IPv6 address, system can
optimize it. For example, system can optimize aa:0000: 00: 00aa: 00aa: 00aa: 00aa:
00aa as aa:: aa: aa: aa: aa: aa: aa.
d) System automatically removes space if there is any space before or after the newly