User manual
69
Server address：www.quickddns.com
Port number：80
Domain name：There are two modes: Default domain name and customized domain
name.
Except default domain name registration, you can also use customized domain name (You
can input your self-defined domain name.) After successful registration, you can use
domain name to login installed of the device IP.
User name: It is optional. You can input your commonly used email address.
Important
Do not register frequently. The interval between two registrations shall be more than 60
seconds. Too many registration requests may result in server attack.
System may take back the domain name that is idle for one year. You can get a
notification email before the cancel operation if your email address setup is OK.
4.11.1.5 UPnP
The UPNP protocol is to establish a mapping relationship between the LAN and the WAN
interface see Figure 4-95. Input the router IP address in the LAN setting under TCP/IP in
Figure 4-91.
UPNP on/off ：Turn on or off the UPNP function of the device.
Status: When the UPNP is offline, it shows as ―Unknown‖. When the UPNP works it
shows ―Success‖
Router LAN IP: It is the router IP in the LAN.
WAN IP: It is the router IP in the WAN.
Port Mapping list： The port mapping list here is the one to one relationship with the
router’s port mapping setting.
List：
Service name：Defined by user.
Protocol： Protocol type
Internal port：Port that has been mapped in the router.
External port：Port that has been mapped locally.
Default: UPNP default port setting is the HTTP, TCP and UDP of the TX-64.
Add to the list: Click it to add the mapping relationship.
Delete: Click it to remove one mapping item.
Double click one item; you can change the corresponding mapping information. See Figure
4-95.
Important:
When you are setting the router external port, use 1024~5000 port. Do not use
well-known port 1~255 and the system port 256~1023 to avoid conflict. For the TCP
and UDP, make sure the internal port and external port are the same to guarante the
proper data transmission.