User manual

67
4.11.1.3 WIFI AP
Note
This function is for some series product only.
The WIFI AP interface is shown as below. See Figure 4-93. Here you can set WIFI hotspot,
so that the network camera can use the hotspot to connect to the network.
 SSID: It is to set SSID name. You can use this name to search the device.
 Password: It is to set SSID password. You can use this password to connect to the
network.
 Authentication mode: Select authentication from the dropdown list.
 Encrypt type: Select encryption type from the dropdown list.
 Start IP/End IP: Input start IP and end IP. The TX-64 can allocate the IP address in the
range you specified here.
 WPS: Click WPS button to enable WPS function. After the network camera enabled this
function, it can automatically connect to the network.
 Remote device: In the list, you can view the network camera(s) that connected to the
TX-64. It includes signal intensity, IP, MAC address, bit rate, channel number, type,
status and etc.
Figure 4-93
 WIFI working status: Here you can view current connection status.
Note:
 After successful connection, you can see WIFI connection icon at the top right corner of
the preview interface.
 When the hotspot verification type is WEP, system displays as AUTO since the device
can not detect its encryption type.
 System does not support verification type WPA and WPA2. The display may become
abnormal for the verification type and encryption type.
After device successfully connected to the WIFI, you can view the hotspot name, IP address,
subnet mask, default gateway and etc.