User manual

Figure 4-90

4.11 Network

4.11.1.1 TCP/IP

The single network adapter interface is shown as in Figure 4-91.

 Network Mode : Includes multiple access, fault tolerance, and load balancing

 IP Version: There are two options: IPv4 and IPv6. Right now, system supports these two

IP address format and you can access via them.

 MAC address: The host in the LAN can get a unique MAC address. It is for you to access

in the LAN. It is read-only.

 IP address: Here you can use up/down button () or input the corresponding number

to input IP address. Then you can set the corresponding subnet mask the default

gateway.

 Default gateway: Here you can input the default gateway. Note system needs to check

the validity of all IPv6 addresses. The IP address and the default gateway shall be in the

same IP section. That is to say, the specified length of the subnet prefix shall have the

same string.

 DHCP: It is to auto search IP. When enable DHCP function, you can not modify

IP/Subnet mask /Gateway. These values are from DHCP function. If you have not

enabled DHCP function, IP/Subnet mask/Gateway display as zero. You need to disable

DHCP function to view current IP information. Besides, when PPPoE is operating, you

can not modify IP/Subnet mask /Gateway.

 MTU: It is to set MTU value of the network adapter. The value ranges from 1280-7200

bytes. The default setup is 1500 bytes. Note MTU modification may result in network

adapter reboot and network becomes off. That is to say, MTU modification can affect

current network service. System may pop up dialog box for you to confirm setup when

you want to change MTU setup. Click OK button to confirm current reboot, or you can

click Cancel button to terminate current modification. Before the modification, you can

check the MTU of the gateway; the MTU of the TX-64 shall be the same as or is lower

than the MTU of the gateway. In this way, you can reduce packets and enhance network

transmission efficiency.

The following MTU value is for reference only.

 1500: Ethernet information packet max value and it is also the default value. It is the