User manual

centre and the WEB) if you enabled current function. System only uploads the alarm

channel status. You can go to the WEB and then go to the Alarm interface to set alarm

event and alarm operation. Go to the Network interface to set alarm centre

information.

 Send email: System can send out the alarm signal via the email to alert you when alarm

occurs. Once you enable the snap function, system can also send out an image as the

attachment. Go to the Main Menu->Setting ->Network->Email interface to set.

 Record channel: you can select proper channel to record alarm video (Multiple choices).

 You need to set alarm record mode as Schedule in Record interface (Main

Menu->Storage->Storage->Record). Note the manual record has the highest priority.

System record all the time no matter there is an alarm or not if you select Manual

mode.

 Now you can go to the Schedule interface (Main Menu->Setting->Storage->Schedule)

to set the record type, corresponding channel number, week and date. You can select

the record type:Regular/MD/Alarm/MD&Alarm. Note, you can not select the

MD&Alarm and MD(or Alarm) at the same time.

 Now you can go to the Encode interface to select the alarm record and set the encode

parameter (Main Menu->Setting->Camera->Encode).

 Finally, you can set the alarm input as the local alarm and then select the record

channel. The select channel begins alarm record when an alarm occurred. Note

system begins the alarm record instead of the MD record if the local alarm and MD

event occurred at the same time.

 Tour: Here you can enable tour function when an alarm occurs. System supports

1/4-window tour. Note the tour setup here has higher priority than the tour setup you set

in the Display interface. Once there two tours are both enabled, system can enable the

alarm tour as you set here when an alarm occurred. If there is no alarm, system

implements the tour setup in the Display interface.

 Snapshot: You can enable this function to snapshoot image when an alarm occurs.

 Buzzer: Highlight the icon to enable this function. The buzzer beeps when an alarm

occurs.

Figure 4-83