User manual

40
In the main menu, from Main menu->Setting->Storage->Schedule, you can go to
schedule menu. See Figure 4-54. Here you can set snapshot period. There are total six
periods in one day. The setup steps are general the same.
Figure 4-54
Note
 Note the trigger snapshot has the higher priority than regular snapshot. If you have
enabled these two types at the same time, system can activate the trigger snapshot
when an alarm occurs, and otherwise system just operates the regular snapshot.
 Only the trigger snapshot supports this function. The regular snapshot function can not
send out picture via the email. But you can upload the picture to a FTP.
4.7.3 Motion detect record/snapshot
4.7.3.1 Motion detect record
a) From Main menu->Setting->Event->Detect, you can go to the following interface.
See Figure 4-55.
Figure 4-55
b) Select motion detect from the event type dropdown list. Select a channel from the
dropdown list and then check the enable button to enable motion detect function.
Here you can set motion detection regions. There are four regions for you to set (red,
yellow, blue and green). Select one of the colored regions first. Then click the left