User manual

37
 Week day: There are eight options: ranges from Saturday to Sunday and all.
 Holiday: It is to set holiday setup. Note you need to go to the General interface (Main
Menu->Setting->System->General) to add holiday first. Otherwise you can not see
this item.
 Pre-record: System can pre-record the video before the event occurs into the file. The
value ranges from 1 to 30 seconds depending on the bit stream.
 Redundancy: System supports redundancy backup function. It allows you backup
recorded file in two disks. You can highlight Redundancy button to activate this
function. Note, before enable this function, set at least one HDD as redundant. (Main
menu->Setting->Storage->HDD Manager). Note this function is null if there is only
one HDD.
 ANR: It is to save video to the SD card of the network camera in case the network
connection fails. The value ranges from 0s～43200s. After the network connection
resumed, the system can get the video from the SD card and there is no risk of record
loss.
 Period setup: Click button after one date or a holiday, you can see an interface
shown as in Figure 4-52.There are four record types: regular, motion detection (MD),
Alarm, MD & alarm.
Following the steps listed below to draw the period manually.
a) Select a channel you want to set. See Figure 4-46.
Figure 4-46
b) Set record type. See Figure 4-47
Figure 4-47
c) Draw manually to set record period. There are six periods in one day. See Figure
4-48.
Figure 4-48