User manual

33
Border Setup
In Figure 4-36, click Border button. Use direction buttons to set camera left limit and then
click Left button.
Use direction buttons to set camera right limit and then click Right button. Now the border
setup process is complete. See Figure 4-40.
Figure 4-40
4.6.1.2 Call PTZ Function
Call Preset
In Figure 4-36, input preset value and then click to call a preset. Click again to
stop call.
Call Pattern
In Figure 4-36, input pattern value and then click to call a pattern. Click again to
stop call.
Call Tour:
In Figure 4-36, input tour value and then click to call a tour. Click again to stop
call.
Call Scan:
In Figure 4-36, input Scan value and then click to call a tour. Click again to stop
call.
Rotate:
In Figure 4-36, click to enable the camera to rotate.
System supports preset, tour, pattern, scan, rotate, light and etc function.
Note:
 Preset, tour and pattern all need the value to be the control parameters. You can
define it as you require.
 You need to refer to your camera user’s manual for Aux definition. In some cases, it
can be used for special process.