User manual

The PTZ setup is shown as you see in Figure 4-33.

Note the commend name is grey once device does not support this function.

The PTZ operation is only valid in one-window mode.

Here you can control PTZ direction, speed, zoom, focus, iris, preset, tour, scan, pattern aux

function, light and wiper, rotation and etc.

Speed is to control PTZ movement speed. The value ranges from 1 to 8.The speed 8 is

faster than speed 1. You can use the remote control to click the small keyboard to set.

You can click and of the zoom, focus and iris to zoom in/out, definition and

brightness.

The PTZ rotation supports 8 directions. If you are using direction buttons on the front panel,

there are only four directions: up/down/left/right.

Figure 4-33

In the middle of the eight direction arrows, there is a 3D intelligent positioning key. See

Figure 4-34. Make sure your protocol supports this function and you need to use mouse to

control.

Click this key, system goes back to the single screen mode. Drag the mouse in the screen to

adjust section size. The dragged zone supports 4X to 16X speeds. It can realize PTZ

automatically. The smaller zone you dragged, the higher the speed.

Figure 4-34

Name

Function

key

function

Shortcut

key

Function

key

function

Shortcut

key

Zoom

Near

Far



Focus

Near

│

Far

►│

Iris



Open

