User manual

Figure 4-31.

Here you can set tour parameter.

 Enable tour: Check the box here to enable tour function.The general tour supports all

types of window split mode.

 Interval: Input proper interval value here. The value ranges from 1-120 seconds.

 Motion tour type: System support 1/4-window tour. Note you need to go to the main

menu->Setting->Event->Video detect->Motion detect to enable tour function.

 Alarm tour type: System support 1/4-window tour. Note you need to go to the main

menu->Setting->Event->Alarm to enable tour function.

 Window split:It is to set window split mode.

Figure 4-31

Tip: On the navigation bar, click / to enable/disable tour. Click save button to save

current setup.

4.6 PTZ

Note: Before you control the PTZ, make sure the PTZ camera and the TX-64 network

connection is OK and the corresponding settings are right.

4.6.1 PTZ Control

After completing all the setting click save button. Right click mouse (click ―Fn‖ key in the

remote control). The interface is shown as in Figure 4-32. Note you can only go to the

PTZ control interface when you are in 1-window display mode.

Figure 4-32