User manual

28
Figure 4-30
Now you can set corresponding information.
 Resolution: There are five options: 1280×1024 (Default), 1280×720, 1920×1080,
1024×768 and 3840×2160. Note the system needs to reboot to activate current setup.
Note 3840×2160 is for some series only.
 VGA+HDMI2: It is for dual-screen operation. Select from the dropdown list according to
your actual situation. Click Apply button, system needs to restart to activate new setup.
For example, 4+4 means for VGA, system max supports 4-window split and for HDMI2,
system max supports 4-window split.
 Transparency: Here is for you to adjust transparency. The value ranges from 128 to 255.
 Channel name: Here is for you to modify channel name. System max support 25-digit
(The value may vary due to different series). Note all your modification here only applies
to TX-64 local end. You need to open web or client end to refresh channel name.
 Time display: You can select to display time or not when system is playback.
 Channel display: You can select to channel name or not when system is playback.
 Image enhance: Check the box; you can optimize the margin of the preview video.
 Original scale: Check the box here to restore video original scale.
Click OK button to save current setup.
4.5.5 Preview Tour Parameters
Set preview display mode, channel display sequence and tour setup.
Set preview display mode: On the preview interface, right click mouse, you can view
right-click menu. Now you can select preview window amount and channel.
 Set channel display mode: On the preview interface, if you want to change channel 1
and channel 4 position, right click channel 1 video window and then drag to the channel
4 video window, release button, you can change channel 1 and channel 4 position.
 Tour setup: Here you can set preview window channel display mode and interval. Follow
the steps listed below.
From Main menu->Setting->System->Display->Tour, you can see an interface shown as in