User manual

25
There are two ways for you to zoom in.
 Drag the mouse to select a zone, you can view an interface show as Figure 4-26.
Figure 4-26
 Put the middle button at the centre of the zone you want to zoom in, and move the
mouse, you can view an interface shown as in Figure 4-27.
Figure 4-27
Right click mouse to cancel zoom and go back to the original interface.
3) Manual record function: It is to backup the video of current channel to the USB device.
System can not backup the video of multiple-channel at the same time.
Click button , system begins recording. Click it again, system stops recoridng. You can
find the record file on the flash disk.
4) Manual Snapshot: Click to snapshot 1-5 times. The snapshot file is saved on the
USB device or HDD. You can go to the Search interface (chapter 4.8.2) to view.
4.5.3 Right Click Menu
After you logged in the device, right click mouse, you can see the short cut menu. See
Figure 4-28.
 Window split mode: You can select window amount and then select channels.
 PTZ: Click it to go to PTZ interface.
 Auto focus: It is to set auto focus function. Make sure the connected network camera
supports this function.
 Color setting: Set video corresponding information.
 Search: Click it to go to Search interface to search and playback a record file.
 Record control: Enable/disable record channel.
 Alarm output: It is to set alarm output mode.
 Remote device: Search and add a remote device.