User manual

15
4 Local Basic Operation
4.1 Boot up and Shutdown
4.1.1 Boot up
Caution
Before the boot up, make sure:
 For device security, connect the TX-64 to the power adapter first and then connect
the device to the power socket.
 The rated input voltage matches the device power on-off button. Make sure the
power wire connection is OK. Then click the power on-off button.
 Always use the stable current, if necessary UPS is a best alternative measure.
Follow the steps listed below to boot up the device.
 Connect the device to the monitor and then connect a mouse.
 Connect power cable.
 Click the power button at the front or rear panel and then boot up the device. After device
booted up, the system is in multiple-channel display mode by default.
4.1.2 Shutdown
Note
 When you see corresponding dialogue box ―System is shutting down…‖ Do not click
power on-off button directly.
 Do not unplug the power cable or click power on-off button to shutdown device directly
when device is running (especially when it is recording.)
4.1.3 Log out
Main menu (RECOMMENDED)
From Main Menu->Shutdown, select shutdown from dropdown list.
Click OK button, you can see device shuts down.
4.2 Startup Wizard
After device successfully booted up, it
goes to startup wizard. See Figure 4-1.
Click Cancel/Next button, you can see
system goes to login interface.
Tip:
Check the box Startup button here,
system goes to startup wizard again
when it boots up the next time.
Cancel the Startup button, system goes
to the login interface directly when it
boots up the next time.
Figure 4-1