User manual

14
3 Device Installation
Note: All the installation and operations here should conform to your local electric
safety rules.
3.1 Check Unpacked TX-64
The protective materials used for the package of the TX-64 can protect most accidental
clashes during transportation. Then you can open the box to check the accessories. Check
the items in accordance with the list. Finally you can remove the protective film of the TX-64.
3.2 About Front Panel and Rear Panel
The model number on the label on the bottom of TX-64 is very important; check according to
your purchase order. (The label in the rear panel is very important too.) Usually we need you
to represent the serial number when we provide the service after sales.
3.3 HDD Installation TX-64
Important: Turn off the power before you replace the HDD. The pictures listed below
for reference only. For the first time install, be aware that whether the HDDs have been
installed. Use 3.5‖ HDD of 7200rpm or higher. Usually we do not recommend the PC HDD.
Follow the instructions below to install hard disk. The following pictures can differ from the
actual product.
1. Loosen the screws of the
upper cover and side panel.
2. Fix four screws in the
HDD (Turn just three
rounds).
3. Place the HDD in
accordance with the four
holes in the bottom.
4. Turn the device upside
down and then turn the
screws in firmly.
5. Fix the HDD firmly.
6. Connect the HDD
cable and power cable.
7. Put the cover in
accordance with the clip and
then place the upper cover
back.
8 Secure the screws in the rear panel and the side
panel.