User manual

117
Figure 5-52
Refer to the following sheet for detailed information.
Parameter
Function
Channel
Select a channel from the dropdown list. Figure 5-50
Pre-record
Input pre-record time here. The value ranges from 0 to 30.
Figure 5-50.
Redundancy
Check the box here to enable redundancy function. Note this
function is null if there is only one HDD. Figure 5-50.
Snapshot
Check the box here to enable snapshot function.
Holiday
Check the box here to enable holiday function.
Setup
Click the Setup button, you can set record period. See Figure
5-50. There are six periods in one day. If you do not check the
date at the bottom of the interface, current setup is for today
only.
Click Save button and then exit.
Copy
Copy function allows you to copy one channel setup to another.
After setting in channel, click Copy button, you can go to
interface Figure 5-52. You can see current channel name is
grey such as channel 1. Now you can select the channel you
wan to paste such as channel 2/3/4. If you wan to save current
setup of channel 1 to all channels, you can click the first box
―ALL‖. Click the OK button to save current copy setup. Click the
OK button in the Encode interface, the copy function
succeeded.
5.8.4.2 Storage Media
5.8.4.2.1 Local Storage
The local interface is shown as in Figure 5-53. Here you can see HDD information. You can
also operate the read-only, read-write, redundancy (if there are more than on HDD) and
format operation.