User manual

116
Parameter
Function
Enable
Check the box here to enable selected function.
Show
message
System can pop up a message to alarm you in the local host screen if
you enabled this function.
Alarm upload
System can upload the alarm signal to the centre (Including alarm centre.
Send Email
If you enabled this function, System can send out an email to alert you
when an alarm occurs.
Buzzer
Check the box here to enable this function. The buzzer beeps when an
alarm occurs.
5.8.4 Storage
5.8.4.1 Schedule
In this interfaces, you can add or remove the schedule record setup and snapshot. See
Figure5-50.
There are four record modes: general (auto), motion detect, alarm and MD & alarm.
There are six periods in one day. You can view the current time period setup from the color
bar.
 Green color stands for the general record/snapshot.
 Yellow color stands for the motion detect record/snapshot.
 Red color stands for the alarm record/snapshot.
 Blue color stands for MD & alarm record/snapshot.
Click on the button ―Setting‖ in Figure 5-50 to see Figure 5-51. Refer to the table below to
see the describtion of the functions.
Figure 5-50 Figure 5-51
Click on the button ―Copy‖ in Figure 5-50 and you get the option to copy the settings from on
camera to all or just one other. See Figure 5-52.