User manual

113
Figure 5-40
5.8.3.1.3 Tampering
The tampering interface is shown as in Figure 5-41. After analysis video, system can
generate a tampering alarm when the detected moving signal reached the sensitivity you set
here. For detailed setups, refer to chapter 5.8.3.1.1 motion detect for detailed information.
Figure 5-41
5.8.3.2 Alarm
Before operation, make sure you have properly connected alarm devices such as buzzer.
5.8.3.2.1 IPC External Alarm (optional)
The IPC External Alarm interface is shown as in Figure 5-42. Network alarm refers to the
alarm signal from the network. System does not anti-dither and sensor type setup.