User manual

110
Refer to the following sheet for detailed information.
Parameter
Function
Enable
You need to check the box to enable motion detection function.
Select a channel from the dropdown list. See Figure 5-35.
Period
Motion detection function becomes activated in the specified periods.
See Figure 5-35 below.
There are six periods in one day. Draw a circle to enable corresponding
period.
Click OK button, system goes back to motion detection interface; click
save button to exit.
Anti-dither
System only memorizes one event during the anti-dither period. The
value ranges from 5s to 600s.
Region
If you select motion detection type, you can click this button to set
motion detection zone. The interface is shown as in Figure 5-36. Here
you can set motion detection regions. There are four regions for you to
set (red, yellow, blue and green). Select one of the colored regions first.
Then click the left mouse button on the start point of the area you want
to select and drag the mouse to select the area. In the test area the
best setting for sensitivity and threshold is 60 and 10 respectively.
Depending on your given environment this settings can be vary.
Sensitivity and threshold can be set in the range from 0 to 100. The
higher the sensitivity and the lower the threshold are set the more
motion is detected. For example: When a leaf falls or a cat is running in
the selected area a motion will be detected.
In this case a subjective setting by the customer is requested!
The corresponding colored area displays different detection areas.
After you completed the setup remember to click the save button to
save current setup. If you click ESC button to exit the region setup
interface system will not save your zone setup.
Record
channel
System auto activates motion detection channel(s) to record once an
alarm occurs. Note you need to set motion detect record period and go
to Storage-> Schedule to set current channel as schedule record.
Record Delay
System can delay the record for specified time after alarm ended. The
value ranges from 10s to 300s.
Alarm out
(optional)
Enable alarm activation function. You need to select alarm output port
so that system can activate corresponding alarm device when an alarm
occurs.
Latch
(optional)
System can delay the alarm output for specified time after an alarm
ended. The value ranges from 1s to 300s.
Show
message
System can pop up a message to alarm you in the local host screen if
you enabled this function.