User manual

104
Quick DDNS and Client-end Introduction
1) Background Introduction
Device IP is not fixed if you use ADSL to login the network. The DDNS function allows you to
access the TX-64 via the registered domain name. Besides the general DDNS, the quick
DDNS works with the device from the manufacturer so that it can add the extension function.
2) Function Introduction
The quick DDNS client has the same function as other DDNS client end. It realizes the
bonding of the domain name and the IP address. You need to refresh the bonding
relationship of the domain and the IP regularly. There is no user name, password or the ID
registration on the server. At the same time, each device has a default domain name
(Generated by MAC address) for your option. You can also use customized valid domain
name (has not registered.).
3) Operation
Before you use Quick DDNS, you need to enable this service and set proper server address,
port value and domain name.
 Server address：www.quickddns.com
 Port number：80
 Domain name：There are two modes: Default domain name and customized domain
name.
Except default domain name registration, you can also use customized domain name (You
can input your self-defined domain name.) After successful registration, you can use
domain name to login installed of the device IP.
 User name: It is optional. You can input your commonly used email address.
Important
 Do not register frequently. The interval between two registrations shall be more than 60
seconds. Too many registration requests may result in server attack.
 System may take back the domain name that is idle for one year. You can get a
notification email before the cancel operation if your email address setup is OK.
5.8.2.6 IP filter
The IP filter interface is shown as in Figure 5-27.
After you enabled trusted sites function, only the IP listed below can access current TX-64. If
you enable blocked sites function, the following listed IP addresses can not access current
TX-64.
Figure 5-27