User manual

101
Refer to the following sheet for detailed information.
Parameter
Function
Mode
There are two modes: static mode and the DHCP mode.
 The IP/submask/gateway are null when you select the DHCP
mode to auto search the IP.
 If you select the static mode, you need to set the
IP/submask/gateway manually.
 If you select the DHCP mode, you can view the
IP/submask/gateway from the DHCP.
 If you switch from the DHCP mode to the static mode, you
need to reset the IP parameters.
 Besides, IP/submask/gateway and DHCP are read-only when
the PPPoE dial is OK.
Mac Address
It is to display host Mac address.
IP Version
It is to select IP version. IPV4 or IPV6.
You can access the IP address of these two versions.
IP Address
Use the keyboard to input the corresponding number to modify
the IP address and then set the corresponding subnet mask and
the default gateway.
Subnet Mask
If modus set to DHCP than the subnetmask is filled in
automatically.
Default Gateway
Mostly this is the IP of your router. Under DHCP Default gateway
is filled in automatically.
Preferred DNS
DNS IP address.
Alternate DNS
Alternate DNS IP address.
For the IP address of IPv6 version, default gateway, preferred DNS and
alternate DNS, the input value shall be 128-digit. It shall not be left in blank.
LAN Download
System can process the downloaded data first if you enable this
function. The download speed is 1.5X or 2.0X of the normal
speed.
5.8.2.2 Connection
The connection interface is shown as in Figure 5-23.
Figure 5-23