User manual

Open the APP Security Advanced and operate according to the steps below:
Figure 6-4
(1) Open the APP and click “Add device” to enter the adding device interface. (2) Click
“Scan QR code” (QR= two dimension) to enter the QR scanning status (Notice: If a pop-up
window shows up authorizing the APP to use the mobile phone camera, please select
YES.) (3) Aim the Smartphone camera at the QR code on the camera and scan it. (4) Enter
the camera password and click “Done”, than the adding of the camera is finished.
Note: The camera initial password is empty, when first using, no need to enter the
password and by clicking “Done” directly the setting will be ok. Important: After first login
change the password! (Chapter 6.4 User settings)
6.2.3 Search device via the LAN to add camera
Connect the camera to the router through the network cable and plug in the power supply to
startup the camera. Open the APP Security Advanced and operate according to the steps
below:
Figure 6-5