User manual

86
4.10.4 Storage
It is to set HDD management, storage parameters, set record plan and record control.
4.10.4.1 Schedule
It is for you to set record plan and snapshot plan.
4.10.4.1.1 Record
Note: You need to have proper rights to implement the following operations. Make sure the
HDDs have been properly installed.
After the system booted up, it is in default 24-hour regular mode. You can set record type and
time in schedule interface.
In the main menu, from Setting->Storage->Schedule, you can go to schedule menu. See
Figure 4-102.
Note you need to go to main menu->Setting->System->General->Holiday to set holiday
date first, otherwise, there is no holiday setup item.
 Channel: Select the channel number first. You can select “all” if you want to set for the whole
channels.

: Sync connection icon. Select icon of several dates, all checked items can be
edited together. Now the icon is shown as
.
 : Click it to delete a record type from one period.
 Record Type: Check the box to select corresponding record type. There are four types:
Regular/MD (motion detect)/Alarm/MD&Alarm.
 Week day: There are eight options: ranges from Saturday to Sunday and all.
 Holiday: It is to set holiday setup. Note you need to go to the General interface (Main Menu-
>System->General) to add holiday first. Otherwise you can not see this item.
 Pre-record: System can pre-record the video before the event occurs into the file. The value
ranges from 1 to 30 seconds depending on the bit stream.
 Redundancy: System supports redundancy backup function. You can highlight Redundancy
button to activate this function. Note, before enable this function, set at least one HDD as
redundant. (Main menu->Setting->Storage->HDD Manager). Note this function is null if
there is only one HDD.
 Period setup: Click button
after one date or a holiday, you can see an interface shown
as in Figure 4-103.There are four record types: regular, motion detection (MD), Alarm, MD &
alarm.
Following the steps listed below to draw the period manually.
 Select a channel you want to set. See Figure 4-99.
Figure 4-99
 Set record type. See Figure 4-100.
Figure 4-100
 Draw manually to set record period. There are six periods in one day. See Figure 4-101.