User manual

71
4.10.2.10 UPnP
The UPNP protocol is to establish a mapping relationship between the LAN and the WAN. Input
the router IP address in the LAN in Figure 4-62. See Figure 4-74.
 UPNP on/off ：Turn on or off the UPNP function of the device.
 Status: When the UPNP is offline, it shows as “Unknown”. When the UPNP works it shows
“Success”
 Router LAN IP: It is the router IP in the LAN.
 WAN IP: It is the router IP in the WAN.
 Port Mapping list： The port mapping list here is the one to one relationship with the router’s
port mapping setting.
 List：
 Service name：Defined by user.
 Protocol： Protocol type
 Internal port：Port that has been mapped in the router.
 External port：Port that has been mapped locally.
 Default: UPNP default port setting is the HTTP, TCP and UDP of the DVR.
 Add to the list: Click it to add the mapping relationship.
 Delete: Click it to remove one mapping item.
Double click one item; you can change the corresponding mapping information. See Figure 4-75.
Important:
When you are setting the router external port, use 1024~5000 port. Do not use well-known
port 1~255 and the system port 256~1023 to avoid conflict.
For the TCP and UDP, make sure the internal port and external port are the same to
guarantee the proper data transmission.
Figure4‐74