User manual

144
Figure5‐65
Refer to the following sheet for detailed information.
Parameter Function
Channel Select a channel from the dropdown list.
Pre-record Input pre-record time here. The value ranges from 0 to 30.
Redundancy Check the box here to enable redundancy function. Note this
function is null if there is only one HDD.
Snapshot Check the box here to enable snapshot function.
Holiday Check the box here to enable holiday function.
Setup
(Sunday to
Saturday)
Click the Setup button, you can set record period. See Figure 5-64.
There are six periods in one day. If you do not check the date at the
bottom of the interface, current setup is for today only.
Click Save button and then exit.
Setup
(Holiday)
Click the Setup button, you can set record period. See Figure 5-64.
There are six periods in one day. If you check Holiday box, current
channel shall record as your holiday setup here.
Copy
Copy function allows you to copy one channel setup to another. After
setting in channel, click Copy button, you can go to interface Figure
5-65. You can see current channel name is grey such as channel 1.
Now you can select the channel you wan to paste such as channel
5/6/7. If you wan to save current setup of channel 1 to all channels,
you can click the first box “ALL”. Click the OK button to save current
copy setup. Click the OK button in the Encode interface, the copy
function succeeded.
5.8.4.2 Local Storage
The local interface is shown as in Figure 5-66. Here you can see HDD information. You can also
operate the read-only, read-write, redundancy (if there are more than on HDD) and format
operation.