User manual

137
Figure5‐53
Figure5‐54
Refer to the following sheet for detailed information.
Parameter Function
Enable You need to check the box to enable motion detection function.
Select a channel from the dropdown list.
Period Motion detection function becomes activated in the specified
periods. See Figure 5-52.
There are six periods in one day. Draw a circle to enable
corresponding period.
Click OK button, system goes back to motion detection interface,
click save button to exit.
Anti-dither
System only memorizes one event during the anti-dither period.
The value ranges from 5s to 600s.
Sensitivity
There are six levels. The sixth level has the highest sensitivity.
Region If you select motion detection type, you can click this button to set
motion detection zone. The interface is shown as in Figure 5-53.
Here you can set motion detection zone. There are four zones for
you to set. Select a zone first and then left drag the mouse to
select a zone. The corresponding color zone displays different
detection zone. You can click Fn button to switch between the
arm mode and disarm mode. In arm mode, you can click the
direction buttons to move the green rectangle to set the motion
detection zone. After you completed the setup, click ENTER