User manual

125
you close the extra stream monitor.

Pulse interval here is for extra stream only. This item is null if you are
using main stream to monitor.

5.8.2.5.2 Mobile
The mobile setup interface is shown as in Figure 5-29.
Here you can activate (send out “on”) or turn off (Send out “off”) the 3G connected phone or
mobile phone, or the phone you set to get alarm message.
Check send SMS box and then input the phone number in the receiver column. Click to add
one receiver. Repeat the above steps you can add more phones. Select a phone number and
then click
, you can delete it. Click OK button to complete the setup.
Figure5‐29
5.8.2.6 PPPoE
The PPPoE interface is shown as in Figure 5-30.
Input the PPPoE user name and password you get from the IPS (internet service provider) and
enable PPPoE function. Save current setup and then reboot the device to get the setup activated.
Device connects to the internet via PPPoE after reboot. You can get the IP address in the WAN
from the IP address column.
Note, you need to use previous IP address in the LAN to login the device. Go to the IP
address item to via the device current device information. You can access the client-end
via this new address.
Figure5‐30
5.8.2.7 DDNS
The DDNS interface is shown as in Figure 5-31.