User manual

118
Mode
WDR For the WDR scene, this function can lower the high bright
section and enhance the brightness of the low bright section. So
that you can view these two sections clearly at the same time.
The value ranges from 1 to 100. When you switch the camera
from no-WDR mode to the WDR mode, system may lose
several seconds record video.
HLC After you enabled HLC function, the device can lower the
brightness of the brightest section according to the HLC control
level. It can reduce the area of the halo and lower the
brightness of the whole video.
Off It is to disable the BLC function. Note this function is disabled
by default.
Profile It is to set the white balance mode. It has effect on the general
hue of the video. This function is on by default.
You can select the different scene mode such as auto, sunny,
cloudy, home, office, night, disable and etc to adjust the video
to the best quality.
 Auto: The auto white balance is on. System can auto
compensate the color temperature to make sure the vide
color is proper.
 Sunny: The threshold of the white balance is in the sunny
mode.
 Night: The threshold of the white balance is in the night
mode.
 Customized: You can set the gain of the red/blue channel.
The value reneges from 0 to 100.
Day/Night It is to set device color and the B/W mode switch. The default
setup is auto.
 Color: Device outputs the color video.
 Auto: Device auto select to output the color or the B/W
video according to the device feature (The general bright of
the video or there is IR light or not.)
 B/W: The device outputs the black and white video.
 Sensor: It is to set when there is peripheral connected IR
light.
5.8.1.3 Encode
5.8.1.3.1 Encode
The encode interface is shown as below. See Figure 5-19.