User manual

101
 
Figure 4-126
4.10.5.3 PTZ
The pan/tilt/zoom setup includes the following items. Select channel first. See Figure 4-127.

PTZ type: There are two options: local/remote. Select remote if you are connecting to the
networkPTZ.SeeFigure4‐128.
 Control mode: You can select control mode from the dropdown list. There are two options:
Serial/HDCVI. For HDCVI series product, select HDCVI. The control signal is sent to the PTZ
via the coaxial cable. For the serial mode, the control signal is sent to the PTZ via the RS485
port.
 Protocol: Select corresponding protocols such as PELCOD.
 Address: input corresponding PTZ address.
 Baud rate: Select baud rate. Data bit: Select data bit.
 Stop bit: Select stop bit. Parity: There are three choices: none/odd/even.
After completed all the setups click save button, system goes back to the previous menu.
Figure 4-127
Figure4‐128

